BOMANN EHBC 547 IX Bedienungsanleitung Seite 20

Dimensions and cabinet cutout
Installation in a cabinet base
Fig. 1
Prepare the cutout of the cabinet base using the dimensional drawing.
Dimensions in mm.
Preparing the worktop for installation of the hob
• The worktop of the furniture must be of 30 to 40 mm in thickness and at least 600 mm in depth. It must be horizontal and the side facing the wall
must be isolated against spilling liquids or humidity.
• The cut surfaces (cutout edges) must be sealed with special varnish, silicone rubber, or cast raisin in order to prevent swelling caused by humidity.
• The hob must be framed by at least 5 cm of worktop.
• Clean the cutout area of the worktop.
Fig. 2
Prepare the cutout of the worktop using the dimensional drawing.
Attach the sealing to the bottom of the hob frame before installing the hob.
SEAL
Fig. 3
When installing the device, ensure sufficient air circulation.
Minimum distances for sufficient air circulation:
Distance to wall cabinets
Space underneath the hob
Distance to the wall
Air inlet
Air outlet
20 20
760 mm
50 mm
20 mm
20 mm
5 mm
Fig. 1
Fig. 2