Troubleshooting - XciteRC Flybar 190 serie Bedienungsanleitung

Troubleshooting

Troubleshooting
Problem Possible Cause
Receiver status Unable to bind receiver
LED flashes conti-
nously
No response Transmitter switched off
after battery is Transmitter batteries low voltage
connected to the Poor contact on transmitter battery
helicopter terminals
Motor does not Helicopter battery low voltage
respond to throttle,
receiver LED
flashes
Main rotor spins Throttle trim accidentally increased du-
after landing ring flight
Servo moves, but Throttle trim too high, safety function
motor fails active
Throttle was not all the way down du-
ring power up
Loose motor connection or damaged
motor
Main rotor spins, Deformed or broken main blades
but the helicopter Helicopter battery low voltage
is unable to take
off
Strong vibrations Deformed or broken main blades
Bent main shaft
Deformed or broken rear blades
Main blade greps overtigthening
XciteRC Flybar 190
Corrective Action
Repeat the Binding process, see chapter
BINDING
Switch transmitter ON
Replace transmitter batteries
Check battery terminals
Charge battery or replace with a fully char-
ged
Check throttle trim and set to neutral
Check throttle trim and set to neutral
Move the throttle stick all the way down
Check motor connectors or replace the
motor
Check and/or replace main blades
Charge battery or replace with a fully char-
ged
Check and/or replace main blades
Replace main shaft
Check and/or replace rear blades
Check screws and re-tight with suitable
force
EN
29