Search For Errors; Possible Cause - TAC V-60 Bedienungsanleitung

Symptom
Unit does not
work after pressing
the power button
No sound on both
channels although
the unit is ready for
use (one of the LEDs
for the input selection
(3) is lit).
40
tube·amp·company

SEARCH FOR ERRORS

Possible Cause

Mains cable is not connected to a suitable
mains wall outlet.
Mains cable has not been firmly inserted into
wall power socket and the device's socket.
Otherwise it may be defective.
Unit fuse or unit is defective.
The currently selected audio source (6)(13) is
giving no signal.
One of the audio settings of a connected
DVD player (analogue/digital) has not been
correctly selected.
The output of the source device is not connec-
ted or is wrongly connected e.g. not connec-
ted to the selected input channel terminal of
the amplifier.
Wrong input channel has been selected at
the amplifier.
Volume (VOLUME) is set too low at the amplifier.
The amplifier is muted (MUTE function).
The speaker cables are not properly connected
to the amplifier's terminals or are defective.
A malfunction has occurred on one or several
tubes.
Countermeasure
Connect to a functioning socket using a
suitable mains voltage.
Check the power cable. If necessary, ex-
change it with a suitable mains cable and
push its plug firmly into wall socket and the
device's power connector.
Contact your dealer.
Switch on the source unit and begin playback.
Correct the settings in the player's setup.
Correct the connection.
Set the amplifier to the input that your desired
source is connected to (6)(13).
Carefully increase the volume (4)(15).
Deactivate the mute function ("MUTE" button
(14)).
Check and tighten the speaker cables at the
amplifier (10) and the speakers.
Have the tubes of the amplifier checked by
your dealer.