TAC V-60 Bedienungsanleitung Seite 29

7
7. INPUT ("S1"..."S4"): Terminal for stereo
audio signals of the source equipment
Here you find four stereo RCA input sockets for
source equipment with analogue stereo (line
level) audio output.
8. OUTPUT REC: Output connectors
assigned to a recording device
If desired, you can connect a recording device
like a CD recorder or a tape recorder to this out-
put. The stereo signal of this output is identical to
the output signal of the selected audio source at
one of the amplifier inputs "S1"..."S4").
9. Face-plate lamp
With this switch you may turn on and off the lamp
of the protective face-plate on the front side of the
appliance.
REAR VIEW
8 9 10 10
10. SPEAKER: Speaker connectors
Output sockets with screw clamps for the connec-
tion of one pair of loudspeakers. You can use
loudspeaker cables with 4 mm banana connec-
tors. Please take note of the information given in
the section "Installation".
11. AC power connector and fuse holder
To establish the power supply, connect the plugs
of the power cable to the device and to the AC
wall outlet. The small plastic housing beneath the
plug opening holds the fuse. Refer to the security
precautions.
11
tube·amp·company
29