Dmx512 Control; Adjusting The Dmx Start Address - EuroLite Dynamic Fog 700 Bedienungsanleitung

DMX512 Control

The unit features 3-pin XLR plugs for DMX connection.
1
Connect the output of your DMX controller to the DMX input DMX IN of the machine with a DMX cable.
2
Connect the DMX output DMX OUT of the machine to the DMX input of the next unit in the chain.
Always connect one output to the input of the next unit until all units are connected.
3
At the last unit, the DMX cable has to be terminated. Plug the terminator with a 120 Ω resistor between
Signal (–) and Signal (+) in the DMX output of the last unit.
4
If the cable length exceeds 300 m or the number of DMX devices is greater than 32, it is recommended
to insert a DMX level amplifier to ensure proper data transmission.
Occupation of the XLR connection:

Adjusting the DMX Start Address

The fog machine reserves one control channel on the DMX controller. To ensure
that the control signals are properly directed to the machine, it must be adjusted to
the DMX start address provided for it on the DMX controller. The address is
adjusted via the DIP switches as a binary number. The address will result when
adding the place values of the DIP switches set to "ON".
As soon as the fog machine receives DMX control signals, the green DMX indicator lights up and the
machine can be operated with the DMX controller.
Occupation of the DIP switches:
DMX control functions:
DMX value
0 – 5 no fog output
6 – 255 minimum fog output (5 %)
www.eurolite.de
Function
maximum fog output (100 %)
21