Clatronic CTV 805 DVB-T Bedienungsanleitung Seite 53

Enlarging a screen section
Changing the viewing angle
Adjusting the volume
Creating a playlist (CD/DVD)
CD:
DVD:
Deleting a playlist (CD/DVD)
05_CTV805_GB.indd 53
You can change the screen section when viewing DVDs, VCDs or images.
Press the ZOOM-button (Fig. 2/23) to change the screen section. Press the button
several times to select the suitable zoom factor or to return to the original zoom
factor.

NOTE:
With the cursor buttons (Fig. 2/8) you can move through the zoomed image.
Some DVDs offer the possibility to select the viewing angle.
Press the ANGLE/TTX-button (Fig. 2/4) to change the viewing angle.

NOTE:
IIf changing the Viewing Angle is not possible, the message „ " will be
displayed.
Repeat pressing the the button to choose a different viewing angle, or to return to
the original viewing angle.
The desired volume can be set wit the volume control (Fig. 1/6) on the device.

NOTE:
With the "/" cursor buttons (Fig. 1/10; Fig. 2/8) you can also adjust the vo-
lume. However, not louder than previously set by the volume control (Fig. 1/6).
You may want to replay the titles, e.g. on a CD, in a different order to the order
determined by the producer. The function „Create Playlist" you can create your
own playing order.
To do this, proceed as follows:
1. Press the PRO/EPG-button (Fig. 2/12). A table is displayed. Here you can enter
the desired order of the tracks (in the case of CDs) or chapters/titles (for DVDs).

NOTE:
However, your playlist will be lost when switching off the DVD-Players or
when inserting a new CD/DVD.
2. Use the Cursor Buttons (Fig. 2/8) to navigate in the table.
3. Enter the desired track (in the case of CDs) or the desired title and chapter
(for DVDs) at the appropriate position in the table. Use the Numerical
Buttons (Fig. 2/3) for this purpose.
4. Use the Cursor Buttons (Fig. 2/8) to select the command "Start" at the
bottom of the screen to save the input.
5. Press the ENTER-button (Fig. 2/7) on the remote control to confirm this
command.
1. Press the PRO/EPG-button. You will now see a table (Fig. CD or Fig. DVD).
2. Use the Cursor Buttons (Fig. 2/8) to manoeuvre to the command "STOP" at
the bottom of the table.
3. Press the ENTER-button (Fig. 2/7) on the remote control to confirm this
command.
4. Press the PRO/EPG button to terminate this procedure.
53
26.01.2010 9:32:43 Uhr