Ot Configuration Module - Wisi STREAMLINE OT serie Startanleitung

OT configuration Module

General
Output data format:
Data rate (bits/s):
Net data rate (bits/s):
Transport stream overflow:
PCR correction:
TS Matrix
Test output: Clicking on the button switches the transport stream to the Ethernet test output.
Using TS switches MPX 1 and MPX 2, you determine which signal path the transport streams follow.
These are depicted by arrows.
Unused slots are deactivated.
ASI loop: Multiplexer Out to QAM: MPX output goes to QAM input and ASI output / Slot 6
MPX out via ASI loop: MPX output goes to ASI output/ Slot 6. ASI input goes to QAM input.
188, 204 Bytes/packet. Default setting 188
Output data rate multiplexer; reference to setting output data format
Net output data rate – multiplexer; reference to 188 Bytes
Green: correct; red: Output data rate too low
Off / On (standard setting: on)
Fig. 1
Fig. 2
GB
- 51 -