Maintenance And Cleaning - Clatronic BSS 7013 Bedienungsanleitung

Rejecting a Call in Bluetooth Mode
Press and hold the
Dial Phone Number Last Dialled
Press the button twice rapidly to call the number you dialled last.
CAUTION:
Do not immerse the device in water.
• There are no parts inside the device which can be maintained by the user.
• Clean the speaker with a slightly damp cloth without cleaning agent.
Problem Cause
The device does The device is
not work. blocked and
"hangs".
You are touching
the speaker grille
and the buttons at
the same time.
Cannot switch the Battery empty.
speaker on.
No audio signal Speaker is
during Bluetooth switched off.
connection.
Speaker is not
paired to the
audio source.
Volume too low.
BSS7013_IM_CTC
button to reject an incoming call.

Maintenance and Cleaning

Troubleshooting
Solution
Turn the device off with the ON / OFF
switch on the bottom of the device. Then
switch the unit back on.
Do not hold the device with your hand on
the speaker grille if you want to operate it.
Charge the battery ( Page 43)
Switch the speaker on.
Check whether the connection exists. If
necessary, pair the speaker to the audio
source again.
Press and hold the
speaker to increase the volume.
Increase the volume on the audio source.
button on the
49
18.10.17