The Controller Mode 2; Charging Of The Helicopter; Preparation - zoopa seventy Anleitung

The controller MODE 2

Gas stick
(up & down)

Charging of the helicopter

! !
Please!note!that!only!full!and!new!batteries!are!able!to!charge!the!helicopter.!If!charging!is!finished!earlier!than!expected,!
the!controller!batteries!need!to!be!replaced!

Preparation

» Open the battery cover on the bottom of the controller and insert the batteries (not included).
» Insert batteries into the controller (batteries not included).
» Place the helicopter on an even surface, so that the tail rotor points into your direction. Check if any obstacles could affect the
flight.
» Step back for at least one metres.
» Switch on the controller and move the accelerator forwards.
» Switch on the controller and move the gas stick down at first, then up and again down – now the helicopter is ready for take off!
IR
Charging plug
Charging LED
Power switch Channel switch
The helicopter is being charged by the controller. Make sure that the!
helicopter!and!the!controller are switched off in advance!
»
the controller.
»
while charging!
During charging, the red LED is blinking and the green LED is on
permanently. Charging is finished as soon as the green LED stops flashing.
This procees takes around 25- 30 minutes.
Power LED
Tail trimming
Pitch / Tail stick
(forward & backward, right & left)
Connect the charging jack of the helicopter with the charging plug of
Now switch on the controller. The helicopter has to be switched off
11
zoopa seventy