Flashlight And Modeling Light; Maintenance; Replacement Of Fuses - Hensel Eh Pro Mini Bedienungsanleitung

User manual // EH Pro Mini (Speed) Flash Head
1:
ON / OFF
9
2
34
Flashlight and modeling lamp
The modeling light of the connected EH Pro Mini flash
head is switched on and off using switch 1. The flash
power and modeling light options are set using power
control and modeling lamp switches of the connected
generator.

Maintenance

EH Pro Mini flash heads do only need very few main-
tenance by the user. The unit should be dry cleaned from
dust from time to time. Before cleaning switch the power
pack off and separate the flash head from the power pack.
Caution:
Under no circumstances is any part of the equipment
to be opened. The equipment is not user-serviceable
and there is dangerous high voltage. In the event of
difficulty notify your dealer.

Replacement of fuses

In case of a broken fuse for the halogen modeling lamp 2,
replace fuse only when the power pack is switched off and
the flash head separated from power pack.
Attention:
Never repair or bridge fuses. For replacement of
fuses please only use fuses with the required value
(please see the table on the next page, Modeling
Lamps and Fuses EH Pro Mini Flash Heads). A wrong
fuse may cause a bursting of the halogen modeling
lamp.
HENSEL-VISIT International GmbH