Hensel EH Pro Mini Bedienungsanleitung Seite 26

User manual // EH Pro Mini (Speed) Flash Head
26
 Do not route cables across the studio floor if possible,
so that damage is excluded. If routing across the studio
floor cannot be omitted, then it must be ensured that
vehicles, ladders, etc. do not damage cables.
Damaged cables and cases must be replaced
immediately by customer service.
 Do not stick any objects into ventilation slots. Venti-
lation slots of the flash head must be kept free during
operation and sufficient air supply must be ensured.
Do not deposit any objects (tools, coffee cups, etc.) on
the flash head.
 Flash systems must not be used in environments with
explosion hazard.
 Flammable materials, like furnishing fabrics, paper,
etc. must not be stored in the immediate vicinity of
flash heads to prevent fire hazards.
 Flash heads must be protected against humidity and
spray water.
 Do not connect accessories from other manufacturers,
even if they use the same or similar connectors.
 Flash heads - hanging from pantographs or ceiling -
must be doubly secured against falling down.
 Do not flash into eyes at short distances (smaller than
5 m), because this can lead to eye damage.
 Do not look directly into the flash reflector, the flash
lamp could be triggered inadvertently.
 Regularly air closed rooms to prevent build-up of inad-
missible ozone concentrations, which can occur due to
the use of high-powered flash systems.
 During work in the studio generating much dust, the
appliance must be covered with suitable dust pro-
tection (not during operation).
HENSEL-VISIT International GmbH