Charging The Battery - BASETech 26 00 47 Bedienungsanleitung

8. Charging the Battery

• Remove the fastening screw that closes the battery compartment on the back of the receiver and
screen.
• Remove the battery compartment lid by pulling it off downwards.
• Place the rechargeable battery in the battery compartment. Observe correct polarity.
• Replace the battery compartment cover.
• Reattach the attachment screws you removed previously.
• Connect the low voltage plug of the mains adapter to the voltage supply connection "DC6V 800mA"
(12).
The shortest charging time can be achieved if the "POWER" (11) slider is in the OFF
position.
Before first commissioning, charging is required for 8-12 hours.
During charging, the "POWER" LED (1) lights up red.
The normal charging duration for a fully discharged battery is approx. 4 hours.
The working duration of the battery is also approx. 4 hours.
22
13) Photo sensor
14) "Power" LED
This LED lights up green when the opera-
ting voltage is properly supplied.
15) Camera lens
16) LEDs
Enable seeing in darkness at a range of
approx. 1.5 to 2 metres.
17) Connections for the power supply
"DC6V 800mA"
18) Holes for hanging up
Enables hanging on the wall.
19) "POWER" slider
Position ON = Camera is activated (if the
operating voltage is properly supplied)
Position OFF = Camera is deactivated
20) Button "VOX ON/OFF"
Position ON = The transmitter transmits a
video or audio signal only when a sound is
perceived. When no audio signal is percei-
ved, signal transmission is suppressed.
Position OFF = Audio and video signals
are transmitted at all times.