Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation of remote control receiver unit for ceiling fans with downrod
diagram 1
1. Please install the receiver unit as shown in diagrams 1 and 2 within the canopy bracket.
The antenna is installed inside the canopy.
2. Please install the electrical wiring according to the diagram on p. 4. Make certain that no
lines are pinched or damaged!
If the switched line to the motor and the switched line to the lights are connected inside
the ceiling fan these must be separated PRIOR to installing the remote control.
3. Please fasten the canopy of the ceiling fan on the ceiling bracket.
Please make sure that the pull switch of your ceiling fan is set to the highest speed.
Once the mains voltage is switched on again, the ceiling fan is available to operation
with the remote control.
Installation of the remote control of CasaFan fans in an extremely flat construction, e.g.
FLAT, GLASHAUS FLAT or OFFICE FAN
Please install the receiver unit of the remote as shown in diagram 3. Once the device is electrically in-
stalled, you may stick the receiver unit to the ceiling with the double-sided sticky points. If this fails,
e.g. when the ceiling decoration is too rough, you may want to attach the receiver unit to the ceiling
plate by means of cable ties. Please put the antenna cable in the housing. Please make sure that the
Canopy
Downrod
Receiver
Canopy
Downrod
diagram 2
pull switch of your ceiling
fan is set to the highest
speed. Once the mains vol-
tage is switched on again,
the ceiling fan can be ope-
rated by means of the re-
mote control.
Fan Housing
Cover
GB
13
Werbung
