Werbung
L'appareil peut monter dans voiture. Il peut être abîmé par
concussion, impact ou tomber de hauteur modeste.
Ce appareil n'est pas un jouet et doit être garder loin
d'enfants.
L'appareil ne peut pas être utilisé pour purposes médicale
ou l'information publique.
Le service réglage ou réparer doivent uniquement faire par
un spécialiste / spécialiste terrain travail.
Si il y a de question que cette instruction opérationnelle
ne réponds pas, contactez SVP avec notre technique
département ou autres experts.
3. Cadre de livraison
a. Capteur UV
b. Stand support
c. 1 x vis plastique nu pour
suspend installation .
d. 1x pole plastique
e. 2 x manche aluminium
f.
2 x connecteur plastique
g. 1 x stand plastique
h. 1 x machan plastique
i.
2 x vis pour fix le capteur
UV sur stand
j.
4 x vis en boit
k. 2 x plaque métal
l.
4 x bots
m. 4 x hex nuts
4. Les éléments opérationnels
1. Lunette
2. Médecin
3. LED
4. Bouton de transmission
5. Batterie
30
6. Configuration
Once a channel has been assigned to the UV sensor, you can
only change it by either removing the batteries or resetting
the unit.
To reset the unit, use a needle and press the "Reset" button
at the bottom of the sensor unit.
Wireless remote unit registration
1.
Take a screwdriver and carefully remove the three "inner"
screws for the battery compartment (5) at the bottom of the
sensor (a).
2.
Remove the battery compartment lid.
3.
Insert 3 AA-size batteries into the battery compartment (5) and
observe correct polarity ("+" and "-" symbols are embossed
next to the relevant locations).
4.
Reinstall the battery compartment lid, ensuring the little tab is
correctly aligned with the groove in the casing.
5.
While applying a little pressure and holding the battery
compartment cover tight to the casing, use the three screws
securely fix the battery compartment lid in place again.
6.
Once the batteries are inserted, the LED indicator (3) On
the sensor's front will flash, indicating that the sensor unit is
automatically transmitting readings to the receiving unit (see
"Intended Use").
7.
If the transmission is successful, the display of the receiving unit
will show a new channel number, the UV index and a relevant
icon. If the transmission is not successful, you can also press
the transmission button (4) on the UV sensor's front to send the
signal manually to the receiving unit (see "Intended Use").
8.
In normal operating mode, if there is no change in the UV
index, the time interval between transmissions will be between
1.5 and 4.0 minutes. If the UV index change is ≥ 1, there will
be an automatic transmission after 30 seconds.
23
Werbung
Kapitel
