Installing The Umts Module - Fujitsu UMTS Montageanleitung

18 – English

Installing the UMTS module

To install the UMTS module, proceed as follows:
► Insert the UMTS module, contacts first, into the bay. Take care not to trap the antenna cables.
► Carefully push the UMTS module downwards.
► Pull any protective tubes carefully away from the antenna contacts.
► Secure the UMTS module with the enclosed screws.
Before connecting the antenna cables, you must first remove any protective tubes from the
!
cables.
To prevent damage to the antenna contacts, connect the antenna cables carefully to the
!
corresponding ports.
Ensure correct connection of the antenna cables:
● Connect the orange antenna (1) to the AUX port
● Connect the yellow antenna (2) to the MAIN port
► Fasten the two antenna cables.
In the case of devices with a TouchStick integrated into the keyboard, make sure the
!
cables of the TouchStick do not get pulled off.
► To fit the cover again, stow the UMTS cables carefully in the recess of the UMTS module bay,
as shown.
► Carefully put the keyboard in place.
► Model E751 with numeric keypad: Fasten the keyboard with the 5 screws.
42
Installing the UMTS module in LIFEBOOK S751 / S781 / E751 / E781
1 2
Fujitsu Technology Solutions