Connecting The Base Station And Power Plug; Connecting The Charging Station; Inserting The Batteries - Olympia 7100 Bedienungsanleitung

Installation

Connecting the Base Station and Power Plug

Connect the plugs to the corresponding sockets in the base station (they
cannot be connected incorrectly because the sockets and plugs are
designed to prevent reverse poling). Lay the cable under the telephone to
the rear. Plug the telephone line in socket F of the telephone connection
socket. Insert the power plug at the other end in the power outlet. The base
station is now ready to operate.
Only use the connection cables supplied.
The base station and charging station have no power switch.
Ensure that a mains power outlet is close by and that the power
plug is easy to access. Check that the voltage specified on the
power plug corresponds with that supplied by local power
network.
Page 22

Connecting the Charging Station

Insert the power plug in the socket on the rear side of the charging station.
Insert the power plug at the other end in the power outlet. The charging
station is now ready to operate.

Inserting the Batteries

Open the battery compartment by sliding the cover down.
Insert two AAA batteries in the compartment, ensuring correct polarity.
The handset does not work if the wrong batteries are inserted.
It is also possible that the handset could be damaged as a
result.
Replace the cover on the battery compartment and slide it on until it locks in
place. Place the handset in the base or charging station. An acoustic
acknowledgement is issued and the charging indicator signals the charging
process has started. Allow the batteries to be charged for 16 hours without
interruption the first time they are charged. If possible, only remove the
handset from the station when the charging process has been completed.
This ensures optimum operation.
OPERATING
INSTRUCTIONS