Cleaning, Maintenance, Storage, Transport And Ordering Of Spare Parts - EINHELL Expert GE-TM 102 B&S Originalbetriebsanleitung

5. Release the locking brake. Slowly actuate the
drive lever (forward). Adjust the cutting height
and driving speed to the grass you are going
to mow.
Note:
•
For optimum mowing results with thick, high
grass, use a low speed.
•
Switch off the mower unit whenever you re-
verse.
•
Switch off the mower unit and set it to the
highest position before crossing over any
obstacles.
Level indicator for the grass basket
The grass basket is supplied with a sensor which
emits a signal tone to tell you when the grass bas-
ket is full. Switch off the mower unit whenever the
signal sounds (Section 6 Mower unit switch). Do
not let the grass basket get too full as it will clog
the ejector chute.
6.2 Emptying the grass basket (Fig. 38)
Important. Never open the grass basket when
the mower unit is running.
1. Apply the locking brake.
2. Pull the release lever for the grass basket
(Item 2) up and out of the holder.
3. The grass basket can now be emptied with
ease.
4. Close the grass basket. Ensure that the grass
basket is fully closed again.
5. Slide the release lever back into the holder
again.
6. Resume mowing, having regard for the safety
instructions as you do so.
Cleaning the ejector chute
The ejector chute can become clogged if you
mow wet grass or if you drive too fast when mo-
wing (Fig. 25/Item 18). Please follow these inst-
ructions in order to remove a blockage:
1. Disengage the drive unit for the attachments,
apply the locking brake, switch off the engine
and pull out the spark boot plug and the igniti-
on key.
2. Check that all moving parts have reached a
complete standstill.
3. Remove the grass basket.
4. Remove the blockage with a stick.
5. Move forward a short distance before swit-
ching on the mower unit again.
Anl_GE_TM_102_BS_SPK7.indb 28 Anl_GE_TM_102_BS_SPK7.indb 28
GB
6.3 After mowing
1. Always allow the engine to cool before you
put the lawn mower in an enclosed area.
2. Remove grass, foliage, grease and oil before
storing the mower. Do not place any objects
on top of the mower.
3. Before using the mower again, retighten all
nuts and screws. Tighten all screws which
were slackened.
4. Also be sure to empty the grass basket.
5. Disconnect the spark plug boot to prevent
unauthorized use.
6. Ensure that you do not park the mower next
to any source of danger. Petrol fumes can
lead to explosions.
7. Only original parts or parts approved by the
manufacturer may be used for repairs
(see address on the warranty certifi cate).
8. Empty the petrol tank with a petrol extraction
pump if you are not intending to use the mo-
wer for an extended period of time.
9. Tell your children not to use the mower. It is
not a toy.
10. Never place petrol near an ignition source.
Always use a can that is approved to store
petrol. Keep petrol away from children.
11. Oil and maintain the equipment.
7. Cleaning, maintenance, storage,
transport and ordering of spare
parts
Important: The enclosed engine manual from
Briggs & Stratton provides maintenance informa-
tion and maintenance interval information on the
engine.
Important:
Never work on or touch any current-conducting
parts of the ignition system while the engine is
running. Pull the spark plug boot from the spark
boot before doing any maintenance or assembly
work. Never carry out any work on the equipment
while the engine is running. Work that is not de-
scribed in these operating instructions should
only be carried out by authorized workshops.
- 28 -
26.11.12 11:45 26.11.12 11:45