Braun MP80 Gebrauchsanweisung Seite 5

5. Put the juice container
juice spout (A). Capacity: 500 ml. The
k
juice container comes with a foam separator
to ensure clear foam free juice.
If it is not required simply remove it from the
juice container. You can, of course, place a
glass or other container underneath the juice
spout to collect the juice.
6. For easier filling, put the filling tray
of the filling shaft
Preparing fruit or vegetables
Important: Use only well ripened fruits, other-
wise the filter 6 may be clogged up which
would result in repeated cleaning of the filter.
Wash or peel the fruit or vegetables you want
to process. Fruit with large pips or stones
should always have these removed first. Proc-
ess seed fruit (such as apples, pears) with peels
and cores. Fruit and vegetables with thick
peels (e. g. citrus fruits, melons, kiwis, beets)
must be peeled first. For grapes, cut off the
main stem. For leaf vegetables (e. g. cabbage
and spinach) and herbs, roll up leaves together
tightly. Cut fruit and vegetables into pieces
large enough to fit into the filling shaft.
Currants and rhubarb are not suitable for
making juice in the Braun Multipress.
Extracting juice
q
Put fruit or vegetables into the filling shaft
Turn the switch 2
with the pusher
j
vegetables while the motor is running.
q
The amount of juice you extract depends on
the nature of the fruits and vegetables. When
processing berries the quantity of juice will
be smaller, because of their high amount of
pectin (pectin is a natural gelatine).
(Special berry presses or steam presses are
better suited to that type of fruit.)
q
Fruit and vegetable juices contain valuable
vitamins and minerals, which quickly
deteriorate when they come into contact with
oxygen or light. Drink juice fresh – right after
it has been extracted.
Emptying the pulp container
You can extract juice continuously until the
pulp container is full:
q
When processing produce with high liquid
content (e. g. tomatoes, grapes, melons):
Do not process more than 3 kg of fruit or
vegetables before emptying the pulp
container.
l underneath the
9
8 (A).
on = «I» and press lightly
(A). Add further fruits or
and filter
4
q
When processing drier produce (e. g. car-
rots, pears, apples):
Empty the pulp container as soon as it
looks full.
If the juice suddenly becomes much thicker
or if you can hear the motor speed slow
down, the filter must be emptied (see «Disas-
on top sembling»).
Empty the pulp and put the appliance together
again.
Disassembling
1. Turn the switch
2. Remove the pusher
tray
9
push it up and pull off downward diagonally
(B). (When replacing the pulp container,
insert the top first.)
3. Press the unlocking buttons
of the juicer (C), to unlock the cover
Remove the cover.
4. Remove the juice ring
filter
6
Cleaning
q
Always remove the plug from the socket first!
q
Clean the motor part
only – never immerse it in water.
All other plastic parts can be washed in a
dishwasher or using warm water and normal
dishwashing liquids. The plastic parts may
8.
discolour when processing food with a high
pigment content (e. g. carrots):
Use vegetable oil to clean before using the
dishwasher.
Important: The filter ist not dishwasherproof,
but can easily be cleaned with a small brush.
Do not use a damaged filter. We recommend
to replace the filter after 5 years (available
at Braun Service Centres).
For space-saving storage, place the filling
tray 9
Subject to change without notice.
6
This product conforms to the EMC-
Requirements as laid down by the
Council Directive 89/336/EEC and to the
Low Voltage Regulation (73/23 EEC).
2 off = «0».
j . Remove the filling
. Swing open the pulp container
5 together with the
. Take the filter out of the juice ring.
with a damp cloth
1
upside down on top of the juicer.
,
4
on both sides
3
7 .
7