Inserting Note Holder; Connection Of Headphones; Connection Of An External Amplifier - Renkforce MK-4100 Bedienungsanleitung

10. Inserting Note Holder

The enclosed note holder can be plugged in at the rear of the keyboard if necessary.
It is only suitable for sheet music or manuscript books, but not for heavy books, etc.

11. Connection of Headphones

You can connect conventional headphones to the 3.5 mm stereo jack socket „OUT" (21) on the rear of the
keyboard.
Playback via the installed speakers is switched off automatically.
Proceed as follows for connection:
• Reduce the volume at the keyboard as far as possible.
• Connect the headphones to the 3.5 mm stereo jack socket „OUT" (21).
• Set a low volume at the keyboard and check it e.g. by playing on the keyboard; carefully put on the head-
phones. Now adjust the volume as you like.
Important!
If the volume is too high, there is the danger of hearing damage. Therefore, set the volume so that
it feels comfortable and is not too loud!

12. Connection of an External Amplifier

You can connect an external amplifier to the 3.5 mm stereo jack socket „OUT" (21) on the rear of the key-
board.
Playback via the installed speakers is switched off automatically.
Proceed as follows for connection:
• Reduce the volume at the keyboard as far as possible. The same applies to the amplifier.
• Connect the 3.5 mm stereo jack socket „OUT" (21) to the amplifier. Always choose an analogue input with
line level for this, e.g. the TAPE or AUX input.
• Set a low volume at the keyboard and the amplifier and check it, e.g. by playing on the keyboard. Now
adjust the volume as you like.
Important!
If the volume is too high, there is the danger of hearing damage. Therefore, set the volume so that
it feels comfortable and is not too loud!
24