Installation - Veho VCC-005-MUVI-HD Handbuch

9. Go remote
The supplied remote
control allows
your Muvi HD to be
remotely operated.

Installation

Velcro
Clip
Pairing your Muvi HD and Remote
Follow the steps below to pair the remote control with your Muvi HD
Record
before use:
Shutter
Stop
Next, press both
remote control within 3 secs to finish the
remote control pairing process.
Note: The remote control range is approx 5 meters.
Changing the remote battery
The Muvi HD remote has a replaceable standard 3V CR2032 battery. To
replace the battery you need to unscrew the four screws on the back
of the remote, remove the back and take out the battery. When putting
the new battery in please ensure that the battery is face (positive side)
up. Please also ensure that the rubber gasket that lines the inside of the
remote is not removed and stays in position when you replace the back
of the remote.
Start with the Muvi HD turned
off. Press and hold
then turn the power switch to
'On', finally release
when the Muvi HD is on.
[Record] and [Stop] on the
[Ok/Shutter]
[Ok/Shutter]
Record
Stop