Getting Started; Setting The Date/Time - Veho VCC-005-MUVI-HD Handbuch

3. Getting started

Charging the Muvi HD
Before using please ensure that the battery is fully charged. Charge the
Muvi HD via the power supply or USB cable. The red power indicator will
flash slowly whilst charging and then will turn solid red, with the battery
icon displayed on the TFT screen, when it is fully charged.
Formatting your microSD Card
Use a high-speed microSD card only and format it in the Muvi HD before
using. If the microSD card has been used on other devices, reformat it in
the Muvi HD before operating.

Setting the date/time

In preview mode, touch [M] to enter
the selection menu. Use [>] to shift
to the setup menu , then [-] to
select the option 'Date/Time' and
then press [Ok/Shutter]. The current
cursor position is indicated by the
yellow number. Use [<] or [>] to move
the cursor and press [Ok/Shutter]
select each number, this number will turn red. Then use the
change the number, move the cursor to
to
[+] or
and finally press [Ok/Shutter].
4. Muvi settings
To access the setting menu touch
the setup menu
then touch [M]
and down, touch
press [Ok/Shutter]
Beep
Self Timer LED
Time Display
Loop Record
Auto Standby
TV Standard
Format
Default
Language
[-] to Frequency
Exposure
[M] in preview mode, use
, press [Ok/Shutter] to set the selected option, and
to exit the menu. Touch [+] and [-]
[<] and [>] to move the cursor left and right, and then
to confirm the option for the current menu.
Turn the key tone on or off
Turn the front LED indicator on or off
Turn the date and time stamp on or off
Turn on to continually overwrite files when the
memory becomes full
Set the power down function for when there is no
activity for 30s, 1m, 5m or Off
Set NTSC or PAL, depending on your area
Note: Disconnect the A V cable before changing the TV system
Format the microSD card and Muvi HD
Note: Formatting will delete all files, including protected ones
Restore factory setting to default
Set the language
Set the light source frequency, 50Hz or 60Hz
depending on your area, in order to avoid the TFT
screen flickering in preview mode or video mode.
Set the exposure control to automatic, centred,
average or spot
[>] to shift to
to move the cursor up