Set Up; Operation; Switching On/Off; Inserting/Ejecting A Cd - Omnitronic XMT-1400 Bedienungsanleitung

5. SET UP

Prior to making or changing any connections, switch off the XMT-1400 and the units to be connected.
1. Install the unit on a plane surface.
2. Connect subsequent units with line level inputs (e.g. amplifier or mixer) via an RCA cable to the analog
RCA output on the rear. Make sure that the right/left occupation is the same at the devices.
3. Use the supplied power cable to connect the XMT-1400 to the mains.
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation. The device
must only be connected with an electric installation carried out in compliance with the IEC standards. The
electric installation must be equipped with a Residual Current Device (RCD) with a maximum fault current of
30 mA.

6. OPERATION

6.1 Switching on/off

1. Switch on the XMT-1400 with the power button. The unit will automatically detect if a CD is inserted
(indication "READING"). If a CD is inserted, the display will shortly indicate the total number of titles and
the total remain time followed by information concerning the first title after the read-in. If no CD is
inserted "NO DISC" will be displayed.
2. Prior to switching the unit off, always terminate the playback with the button
button to switch off the unit.

6.2 Inserting/ejecting a CD

1. To insert a CD, open the CD tray with the button
"OPEN".
2. Insert the CD with the lettering facing upwards and close the CD tray again with the button
The display will show "CLOSE" and the read-in starts (indication "READING"). After the read-in, the
player will be set to pause on the first title.
3. To change a CD, first set the player to pause with the button
locked against unintentional opening.

6.3 Loading/removing USB devices and memory cards

1. Insert USB devices into the USB port.
2. Insert an applicable memory card with its contacts pointing downwards to the right so far into the card
slot, until it engages.
3. To remove a USB device, disconnect it from the USB port.
4. To eject a memory card, slightly press it into the slot until it comes out and can be removed.
CAUTION! Never attempt to remove data carriers in play mode. Otherwise damage or loss of data
may occur.
Regarding data carriers
• This unit supports MSC (Mass Storage Class) USB storage devices 1.0, 1.1, 2.0 including
external portable flash memory devices and digital audio players. However, hard discs, optical
discs such as external CD/DVD drives will not be recognized.
• Depending on the device used, proper playback may not be possible with all USB storage
devices.
• This units supports SD and SDHC memory cards.
• When connecting a data carrier with a large number of folders and files, some time may be
required to read in the contents.
[EJECT] (control LED lights). The display will show
. While playing a CD, the CD drive is
27/32
. Then press the power
[EJECT].
00058520.DOC, Version 1.0