Using The Remote Control - Pioneer F-F6-J Bedienungsanleitung

03 Controls and displays
6 MPX
Use to switch between stereo and mono
reception during FM broadcasts. If the signal is
weak, switching to mono may improve the
sound quality (page 15).
7 VOLUME
Use to adjust your Pioneer amplifier's sound
volume.
8 DIMMER
Dims or brightens the display (or switches the
backlight off).
9 DISP
Use to select the display mode (page 18, 24).
10 Preset channel range buttons
(A/B/C, D/E/F, G/H, I/J)
Use to tune in preset broadcast stations.
11 A.PRESET/A.TUNE
When pressed during FM or AM mode,
receivable stations are automatically stored in
the preset memory in order starting from
preset channel A1.
Hold the button depressed for two seconds or
longer during DAB mode to perform full scan
operation (Full band and L-band).
Press the button briefly during DAB mode to
perform a local scan (UK band III) for UK
broadcast services (UK stations are in the
range of 11B to 12D).
12 Tuning buttons
ENTER
Selects an option or executes a command.
TUNE +/–
Use to change reception frequency.
ST +/–
Selects station preset when listening to the
radio.
13 MUTE
Use to activate the mute function of your
Pioneer amplifier.
12
En

Using the remote control

Keep in mind the following when using the
remote control:
• Make sure that there are no obstacles
between the remote and the remote sensor
on the unit.
• The remote has a range of about 7 m at an
angle of about 30º from the remote sensor.
• Remote operation may become unreliable
if strong sunlight or fluorescent light is
shining on the unit's remote sensor.
• Remote controllers for different devices
can interfere with each other. Avoid using
remotes for other components located
close to this unit.
• Replace the battery when you notice a
decrease in the operating range of the
remote.