Troubleshooting; Environmental Information - Jgc Rrmp3100 Bedienungsanleitung

TROUBLESHOOTING

Troubleshooting
If a fault occurs, first ckeck the points listed below before taking the set for repair.
Do not open the set as there is a risk of electric shock.
If you are unable to remedy the problem by following these hints, call service and support at the phone number
shown below.
Warning:
Under no circumstances should you try to repair the set yourself, as this will invalidate the warranty
Problem
No sound / power
Display does not function properly /
No reaction to operation of any of
the controls
The CD skips tracks
No disc indication
CD Playback does not work
Service & support hotline: 0180 5 - 22 17 84 (€ 0,12 / Min.) (Germany only)
If the product needs to be sent to the servicecenter, please use the provided return sticker. If the sticker is mis-
sing, please call service & support.

Environmental information

We have done our best to reduce the packaging and make it easy to separate into 3 materials: cardbord, paper
pulp and expandable polyethylene.
Your set consists of materials which can be recycled if disassembled by a specialized company. Please observe
the local regulations regarding the disposal of packaging, dead batteries and old equipment.
Cause
Volume not adjusted
Power cord not securely connected
Batteries dead / incorrectly inserted Insert (fresh) batteries correctly
Electrostatic discharge
CD damaged or dirty
Program is active
No CD inserted
CD badly scratched or dirty
Laser lens has steamed up
CD-R is blank or the disc is not
finalized
CD badly scratched or dirty
Laser lens steamed up
Solution
Adjust the Volume
Connect the AC cord properly
Switch off und aunplug the set.
Reconnect after a few seconds
Replace or clean CD
Quit program mode
Insert a CD, CD-R or CD-RW
Replace or clean CD
Wait until lens has cleared
Use a finalized CD-R
Replace or clean CD
Wait until lens has adjusted to room
temperature