MAINTENANCE & SAFETY
Precautions & General Maintenance
Place the set on a hard and flat surface so that the
system does not tilt.
Do not expose the set, batteries or CDs to
humidity, rain, sand or excessive heat caused by
heating equipment or direct sunlight.
Do not cover the set. Adequate ventilation with a
minimum gap of 6 inches between the ventilation
holes and surrounding surfaces is necessary to
prevent heat build-up.
The mechanical parts of the set contain
self-lubricating bearings and must not be oiled or
lubricated.
To clean the set, use a soft dry cloth. Do not use
any cleaning agents containing alcohol, ammonia,
benzene or abrasives as these may harm the
housing.
CD player and CD handling
The Lens of the CD player should never be touched!
Sudden changes in the surrounding temperature can cause condensation to form and the lens of your CD
player to cloud over. Playing a CD in this condition is impossible. Do not attempt to clean the lens. Leave the
set in a warm environment until the moisture evaporates.
Always close the CD door to keep the CD compartment dust-free. To clean, dust the compartment with a
soft dry cloth.
To clean the CD, wipe in a straight line from the centre towards the edge using a soft, lint-free cloth. Do not
use cleaning agents as they may damage the disc.
Never write on a CD or attach any stickers to it