Radio Operation - JGC RRMP-6910 Bedienungsanleitung

RADIO OPERATION

• Set the FUNCTION switch (19) on the device to RADIO. The device is now in radio operation.
• Press the /BAND button (38) to switch between FM (frequency modulation) and AM (amplitude
modulation).
• With the /STOP/FM. MODE button (31), you can switch between mono and stereo reception. Only FM
stations will be broadcast in stereo. On the display, the following symbol is shown for stereo
reception: ((ST)).
If the FM stereo reception is weak or noisy, you can switch into mono operation in order to improve the
reception quality.
Antennas
• The device is equipped with two antennas – a telescopic antenna (16) for the FM area and an internal ferrite
antenna for AM.
• Pull the telescopic antenna fully out and rotate it in the direction with the best reception (for FM band). Find
the optimum position for the device in order to get the best possible reception (for AM band).
Station searching
• Manual search
Repeatedly press the button
manual method for fine-tuning of weak or distant stations which cannot be recognised independently from
the automatic tuning.
• Automatic search
Hold the button
radio searches for the next strong signal. Repeat this procedure until you find desired station. End the
automatic station search by pressing the button
Station programming
• You can store up to 50 stations. There is storage space for 30 FM and 20 AM stations available.
• Select a station with the manual or automatic station search.
• Press the SKIP+10/FOLDER/MEM.SET button (33). The number of the current storage space flashes.
Additionally, MEM will be shown on the display (7).
• Select the desired storage space with
• Press the SKIP+10/FOLDER/MEM.SET button (33) again in order to confirm saving of the shown station in
this storage space. Proceed with saving further stations.
• Once you have saved several stations, you can call them up by pressing the REPEAT/PROG/MEMORY
button (36). Then press
will be shown as well as the frequency and the word MEM.
• You erase a station from the storage space if you save another station on this storage space. The previously
saved station will be erased.
Notes:
• The saved stations will not be erased if you unplug the device.
• If you do not press any buttons for 10 seconds, the station programming will be cancelled.
32
JGC-RRMP-6910-IM-DE-EN-V2.indb 32
(37) or (32) until the display shows the desired radio station. Use the
(37) or (32) down until the display begins to move. Then let go of the button. The
(37) or
(37) or (32) to select the desired stored station. The storage space number
(37) or (32) again.
(32).
11/08/2009 1:13 PM