Radio Operation - iCES ICRP-211 Bedienungsanleitung

RADIO OPERATION

1. Press the ON Button until the display change to radio mode.
2. Select the AM or FM band by pressing the BAND Button. Then the AM or FM
indicator will light on.
3. Tune a station by pressing the TUNING UP/DOWN Button.
Pressing either TUNING UP/DOWN Button for more than 0.5 seconds to activate
the automatic tuning mode. The automatic tuner will scan up or down and lock onto
the next station. If the automatic tuning does not precisely tune into a radio station,
press the TUNING UP/DOWN Button to adjust the tuning.
4. Adjust the volume by pressing VOLUME UP/DOWN Button.
The volume indicator will be changing and represent the volume level.
5. To turn off the radio, press once the ON Button then it will return to Standby mode.
6. After tuned into a radio station, the unit will return to show the current time instead of
the radio frequency after a few seconds. If you want to check the radio frequency, press
once the TUNING UP or TUNING DOWN button then the unit will show the radio
frequency for a few seconds.
STORES PRESET STATIONS
Up to 20 stations (10 AM and 10 FM) can be stored in memory :
1. Tune to a desired station as described in above.
2. Press the Time Set / Memory Button, the Preset Station Number will be flashing.
3. Select your desired Preset Station Number you wish to store your station while the
Number is flashing by pressing once or more times the Preset Button. When the
desired number is flashing, press once again the Time set / Memory Button. Then the
Number will stop flashing. Now the station is stored in the desired preset station.
To replace a station stored in the memory, repeat all the stages described above. The
new station will replace the previously stored one.
To receive Preset Stations :
1. Under RADIO mode, select the waveband by pressing the Band Button.
2. Press once or more times the Preset Button to select the desired Preset Station
Number.
TO SET THE ALARM TIME AND THE ALARM MODE
Make sure the unit is in Standby mode, that means the AM or FM Indicator is not light on.
1. Press once the Alarm Button. Then the alarm time will be flashing.
2. Press the Hour Button to adjust the hour digit.
3. Press the Minute Button to adjust the minute digit.