SOUNDMASTER SCD5350RO Gebrauchsanleitung Seite 8

14
1. Volume
2. phone jack
3. Function selector
4.
5. CD Program
6. CD Repeat
7. CD SKIP backwards |<<
8. CD SKIP forward >>|
9. CD STOP
10. CD PLAY/Pause ► ||
Power Supply
Check if the power voltage, as shown on the type plate located on the bottom of the set, corresponds to your local AC power supply.
Connect the power cord to the AC MAINS inlet and the wall outlet. The power supply is
Batteries (not incl.)
Open the battery compartment and insert 8x 1,5V UM-2/C Batteries with the correct polarity as indicated by the + and – symbols inside
the compartment.
Do not mix battery types: e.g. alkaline with carbon zing. Only use batteries of the same type for the set. When inserting new batteries,
do not try to mix old batteries with the new ones. Remove the batteries if the set is not to be used for a long time.
Volume
Adjust the sound with the Volume switch
Microphone
1. Slide the FUNCTION selector to (CD MIC, TAPE(OFF) , RADIO) position. Note: In TAPE(OFF) mode, the mic function operate
with playing tape.
2. Insert the microphone plugs into Mic jack, and then the microphones can be connecting.
3. Rotate the VOLUME button to adjust sound
9
15
ENGLISH
16
11. CD compartment
12. Switch FM/FM-ST
13. Tuning control
14. Cassette recorder keys
15. LCD display
16. Microphone
17. FM telescopic antenna
18. Battery compartment
19. AC mains
Economic Saving power mode
If the unit is idle for 1 minutes, it will
automatically switch to Saving power mode. Press
the >/II PLAY/PAUSE button to resume.
.
ENG 1
17 18 19
1,5V x 8 batterie R14 UM2
C size (not include)