Viewing Pictures From Connected Equipment; Using The Menu; Navigating Through Menus - Sony BRAVIA 13W1v2-4 Bedienungsanleitung

Viewing pictures from
connected equipment
Switch on the connected equipment, then
perform one of the following operation.
For equipment connected to the scart sockets using a
fully-wired 21-pin scart lead
Start playback on the connected equipment.
The picture from the connected equipment appears on
the screen.
For an auto-tuned VCR (page 11)
In analogue mode, press PROG +/-, or the number
buttons, to select the video channel.
For other connected equipment
Press / repeatedly until the correct input
symbol (see below) appears on the screen.
1/ 1, 2/ 2,
Audio/video or RGB input signal through the scart
socket / 1, 2 or 3.
source has been connected.
4:
Component input signal through the Y, P
sockets / 4, and audio input signal through the
L/G/S/I, R/D/D/D sockets
5:
Digital audio/video signal is input through the HDMI IN
5 socket. Audio input signal is analogue only if the
equipment has been connected using the DVI and audio
out socket.
6/ 6:
Video input signal through the video socket
audio input signal through the audio socket L/G/S/I
(MONO), R/D/D/D sockets
the equipment is connected to the S video socket
instead of the video socket
signal is input through the S video socket
Additional operations
To Do this
Return to the normal Press DIGITAL or ANALOG.
TV operation
Access the Input Press OK to access the Input signal
signal index table index table. (Then, only in
analogue mode, press ,.) To
select an input source, press M/m,
then press OK.
3/ 3:
appears only if an RGB
/C , P /C
B B R R
/ 4.
6, and
6. appears only if
6
6, and S video input
6.

Using the Menu

Navigating through
menus
1
Press MENU to display the menu.
2
Press M/m to select a menu icon.
3
Press M/m/</, to select an option.
4
Press M/m/</, to change/set the
setting, then press OK.
To exit the menu, press MENU.
To return to the last display, press <.
2,3,4
4
1
Continued
21
GB