Other Functions; Controlling The Unit With The Tv Remote Control - Pioneer SBX-B30 Bedienungsanleitung

Chapter 4

Other Functions

Controlling the unit with
the TV remote control
The unit can learn TV remote control operation
to enable operation of the unit with the TV
remote control (learning function).
The following three functions can be operated
with the TV remote control.
• Power on/off (standby mode)
• Volume down
• Volume up
Note
• This function may not be supported depending on
the TV remote control. If it is not supported, use the
remote control supplied with the unit.
1 Turn off the TV.
2 Press u/I on the unit to turn off the
power.
3 Hold down both VOLUME+ and VOLUME–
on the unit for three seconds to enter
remote learning setting mode.
The indicators flash green and the unit
enters remote learning setting mode.
4 Learning the three types of TV remote
signal.
Learning switching between power on and off
(standby mode).
1 Press the u/I on the unit.
Only the unit's TV indicator will flash green.
2 Within one minute, point the TV remote
control at the remote control sensor on the unit
and press STANDBY/ON twice. (The TV remote
control signal needs to be received twice by the
unit.)
The unit's TV indicator will change from
flashing green to being constantly lit.
TV remote control
Note
• If the green flashing continues then the learning
has not been completed. Press the
again and repeat the procedure.
• The following are the potential causes of the
indicator flashing red.
– A signal from a type of TV remote control that
cannot be learned : This TV is not supported.
– If another button has already learned the same
remote signal : First erase the already learned
function.
– If a signal from a different remote control was
received during learning : Perform the operation
again.
Learning volume down.
1 Press VOLUME– on the unit.
2 Within one minute, point the TV remote
control at the remote control sensor on the unit
and press VOLUME– twice.
The unit's BD/DVD indicator will change from
flashing green to being constantly lit.
Learning volume up.
1 Press VOLUME+ on the unit.
2 Within one minute, point the TV remote
control at the remote control sensor on the unit
and press VOLUME+ twice.
The unit's STB ANALOG indicator will change
from flashing green to being constantly lit.
5 Hold down both VOLUME+ and VOLUME–
on the unit for three seconds to exit
remote learning setting mode.
Caution
• If learning failed, perform the operation
again while the power of the TV is off. The
light from the TV screen may affect remote
control learning.
• If the same operation is performed with
a different TV remote control (or different
buttons) after learning, the old functions will
be overwritten with the new ones.
• If you use the remote control when the
power states of the unit and TV are opposite
after the unit has learned the TV power
button, the function will not work properly. In
this case, press u/I on the unit so that the
power states of the unit and TV become the
same before using the remote control.
• The TV remote control signals may be
received by and operate both the TV and
the unit. Set one of the following.
– Set audio output from the built-in speakers of
the TV to OFF.
– Set the TV volume to the minimum level.
Other Functions 13
En
on the unit
u/I