AEG L 76460 TL Handbuch Seite 20

20
With some problems, the acoustic
signals operate and the display
shows an alarm code:
•
- The appliance does not fill
with water.
•
the water.
Problem
The appliance
does not fill with
water.
The appliance
does not drain the
water.
The appliance
door is open or
not closed correct-
ly.
The anti-flood de-
vice is on.
The spin phase
does not operate.
- The appliance does not drain
Possible cause
The water tap is closed.
The water inlet hose is
damaged.
The filters in the water in-
let hose is blocked .
The water tap is blocked
or is furred with lime-
scale.
The connection of the
water inlet hose is not
correct.
The water pressure is too
low.
The water drain hose is
damaged.
The filter of the drain
pump is blocked.
The connection of the
water drain hose is not
correct.
A washing programme
without the drain phase
is set.
The function Rinse &
Hold is on.
The spin phase is off.
•
- The appliance door is open or
not closed correctly.
•
- The anti-flood device is on.
WARNING!
Deactivate the appliance before
you do the checks.
Possible solution
Open the water tap.
Make sure that the water inlet
hose has no damages.
Clean the filters. Refer to 'Care
and cleaning'.
Clean the water tap.
Make sure that the connection is
correct.
Contact your local water authori-
ty.
Make sure that the water drain
hose has no damages.
Clean the filter of the drain
pump. Refer to 'Care and clean-
ing'.
Make sure that the connection is
correct.
Set the drain programme.
Set the drain programme.
Close the door correctly.
• Disconnect the appliance.
• Close the water tap.
• Contact the service centre.
Set the spin programme.