Waves IVC-107001 Bedienungsanleitung Seite 37

IVC-107001
PARTS AND ACCESSORIES
1. Locking block
2. Combo brush
3. Extension tube
4. Carrying handle
5. Hose
6. Floor brush
7. Decorative button
8. On/off switch pedal
9. Cover
10. Sliding block
OPERATING MODE
1. Connect the hose accessories:
Insert the hose into the hose socket and rotate around 30 degree in clockwise direction to firm
the connection.
2. Connect the extension tube to the curved hose end.
Connect the different nozzle tools/floor brush to the tube for different cleaning purposes. The
floor brush has two positions, one for hard/even and one for soft/textile surfaces-Choose the
right one. Use the combo brush for cleaning narrow surface.
This vacuum cleaner can also be used for water absorption.
3. Turn on the appliance:
Insert the plug into the power socket.
Make sure that the power supply corresponds to the required power mentioned on the rating
label. Press the on/off switch pedal to turn on the power.
4. Turn off the appliance:
After using, press the on/off switch pedal, the appliance is turned off. Pull the plug out of the
power socket.
5. To move the appliance from room to room, unplug and carry it by using the handle. Never pull
the appliance by its cord when moving.
NOTE: You can adjust the airflow by pushing the sliding block (10) up and down.
MAINTENANCE
1. Release the locking block to open the housing.
2. Remove the dust bag.
3. Then take a new one, insert it into the bag holder. Paper dust bag cannot be re-used; cloth bag
can be re-used after cleaning. Attention: the opened cloth bag must be completely closed by the
clip.
EN