Use And Function - Waves DC-103710.1 Anleitung

32. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified person in order to avoid a hazard.
33. This appliance is intended to be used in household and similar applications such as: staff kitchen
areas in shops, offices and other working environments; farm houses; by clients in hotels, motels
and other residential type environments; bed and breakfast type environments.
WARNING
IMPORTANT:
If the suction opening of the unit, the hose or the tube is blocked, switch off the vacuum cleaner and
remove the blocking substance before you start the unit again.
1. Do not operate the vacuum cleaner too close to heater or radiators.
2. Before inserting the power plug into the wall outlet, make sure that your hands are dry.
3. Before you start the unit, make sure to remove large or sharp objects that might damage the dust
tank and hose.
4. When pulling out the power plug from the wall outlet, pull the plug not the power cord.
5. Do not use without all filters in place.
6. When using, if you learn of squeak from the cleaner, it must be suction appears to be reduced, so
you must stop (make sure the cleaner is not plugging), then clean the all air filter.
WARNING:
Hold the plug when rewinding the cord. Do not allow the cord to whip when rewinding.
USE AND FUNCTION
Assembling vacuum cleaner
Note:
Always remove the power plug from the wall outlet before assembling or removing accessories.
1. Attaching the Flexible Hose into the vacuum connect the flexible hose into the air intake duct, push
in until you hear a "click" sound, indicating it is in its locked position.
2. Fitting the tube to the curved wand/hose extension. Push the tube into the curved wand/hose
extension.
3. Fitting the floor brush to the tube. Push the tube into the floor brush. Adjust the tube to the desired
length.
BUTTON FUNCTION INTRODUCTION
Note:
Once all attachments are in place, unwind a sufficient length of cable and insert the plug into the wall
outlet. A yellow mark on the power cord shows the ideal cable length. Do not pull the power cord
beyond the red mark.
1. Insert the power plug into the wall outlet.