Melissa 640-279 Anleitung Seite 30

Figure 7
4. The inner and outer filters both
need cleaning. Brush them with a
small brush and/or wash them in
tepid water. Add a little detergent
if necessary. Check that the filters
are COMPLETELY dry before
refitting them. NEVER insert a wet
filter into the appliance.
5. Insert the inner filter into the outer
filter and place them in the dust
container. Press the filters down
far enough so that they fit tightly
to the sides of the dust container.
The filters can only be fitted in one
position.
6. Fit the dust container by pressing
it firmly against the motor until you
hear a click.
7. Replace the hand-held vacuum
cleaner on the appliance.
CLEANING
• Clean the appliance by wiping
it with a damp cloth. A little
detergent can be added if the
appliance is heavily soiled.
• Do not use scouring pads,
steel wool or any form of strong
solvents or abrasive cleaning
agents to clean the appliance,
as they can damage the external
surfaces of the appliance.
• Clean the filters as described
above. Replace the filters with the
same type when worn or when
they can no longer be cleaned
properly.
•
Figure 8
Cleaning the brush of the floor
nozzle
There is a rotating brush (13) in the
floor nozzle. The brush must be
cleaned if it becomes covered in hair
or other substances.
1. Switch appliance off.
2. Detach the floor nozzle from the
3. Turn the floor nozzle upside down
4. Remove hair, etc. from the brush.
IMPORTANT! Check the floor nozzle
and the brush regularly to prevent
delicate flooring becoming scratched.
30
Check that the dust container
and the filters are COMPLETELY
dry before re-assembling the
appliance and using it.
appliance by pressing the lock
tab at the back of the floor nozzle
connector and sliding off the floor
nozzle.
so that you can see the rotating
brush.
- If necessary, the brush can
be detached by loosening the
screw holding the cover at
the right side of the brush and
removing the cover.
- Detach the brush, clean it and
remount the brush and the
cover.
- Similarly, the castors can be
cleaned by loosening them
with a screwdriver, cleaning
them and remounting them.