Inhaltsverzeichnis
Werbung
Elite 23 Installation Guide, Rev. A
Terminating the drive
ST423451N drives are terminated with permanently mounted IC
active terminators. If you install one of these drives and it is not
on the end of the SCSI bus, disable the terminators by removing
the TE jumper from pins 19 and 20 of connector J4A (see Figure
7). If you install the drive on the end of the SCSI bus, enable ter-
mination by installing a jumper on pins 19 and 20 of connector
J4A.
Terminator Enabled (TE)
Terminator Disabled (TE)
Figure 8.
Pin 1
J4A
Pin 1
Terminating the drive
N drives
J4A
J01
Pin 1
Pin 19
35
J4B
Werbung
Inhaltsverzeichnis
