Inhaltsverzeichnis
Werbung
Elite 23 Installation Guide, Rev. A
For information about how to terminate your drive, refer to the
appropriate drive-specific section.
Internal SCSI cable
Internal
SCSI device
SCSI device
Figure 2.
Terminator power
You usually will not need to change this option and can normally
leave the drive configured as it was shipped from the factory. For
information about how to change the terminator power option on
your drive, refer to the appropriate drive-specific section.
I/O circuits and data path widths
• WD models use differential I/O circuits. You cannot mix these
models with single-ended models (N, W) on the same SCSI
bus. The circuits are incompatible with each other.
• W and WD, models have a "wide" (16-bit) SCSI data bus
rather than the standard (non-wide) 8-bit SCSI data bus; how-
ever, you can use these wide drives on a standard (non-wide)
8-bit data bus.
Internal SCSI cable
Internal
SCSI device
SCSI device
Terminate
Internal
Controller
SCSI bus termination
Internal
Controller
External
SCSI
cable
Terminate
External
SCSI device
SCSI device
19
External
Werbung
Inhaltsverzeichnis
