Comunello Mowin R-control Bedienungsanleitung Seite 13

4. TRASMITTER R6-CONTROL
4.1 Functioning of the buttons UP, DOWN and STOP
UP Activates the automation GOING UP
DOWN Activates the automation GOING DOWN
STOP it stops the automation
4.2 Functioning of the button SELC
By this button it is possible to select the channel to be used for the radio transmission.
1. Press button SELC until selected the desired channel: the corresponding led is on for some seconds
2. Press one of the buttons UP, DOWN or STOP to transmit the control
To select all the channels at the same time press several times the button SELC until all the leds are on.
To display the channel set, press once the button SELC.
4.3 Functioning of the button SELG
By this button it is possible to program and select the GROUPS of channels to be used for the radio
transmission. It is possible to store up to 8 groups of channels; stored the eighth, a new group will replace
the first one.
1. Press the button SELC until selected the first channel to link to the group
2. Press the button SELG: the led linked to the selected channel starts blinking
3. Press the button SELC until selected the second channel to link
4. Press the button SELG: the led linked to the selected channel starts blinking
5. Repeat the procedure for all the desired channels: the leds linked are on till the end of the procedure
6. Once selected all the channels wait for the leds to switch off: the group has been stored and it is possible
to display it by pressing the button SELG
When the groups are more than one, to select the desired group proceed as follows:
1. Press the button SELG several times until selected the desired group:
the leds linked to the channels are on for some minutes
2. Press one of the buttons UP, DOWN or STOP to transmit the control
13
Italian Movements