Stop The Engine And Machine; Drive The Wheel; Grass Catcher; Cutting Height Adjustment - IKRAmogatec BRM 1746 SSM TL Betriebsanleitung

4. Both hands holding the handle and maintain can nor-
mal operation (Fig. 9)
illustration 9

STOP THE ENGINE AND MACHINE

Release the break control handle to stop the engine and
blade, thus stopping the lawnmower from operating.

DRIVE THE WHEEL

SELF-DRIVE: grasp the wheel drive handle bar and the
unit will move forward by the engine. (Fig. 9)
PUSH THE MACHINE BY MANUAL: Release the wheel
drive handle bar, and then you can push the unit manual.

GRASS CATCHER

Empty and clean the bag, make sure it is clean and ensu-
re its meshwork is ventilated.

CUTTING HEIGHT ADJUSTMENT

Apply outward pressure to disengage lever from rack,
move lever forward or back to adjust height.
GB | Operating Instruction
3. MAINTENANCE, CLEANING AND
Stop the engine and unplug the spark plug before
any repairing or maintenance operations
• Refer to separate engine manual for engine mainte-
nance instructions.
• Stop the engine and unplug the spark plug before any
repairing or maintenance operations.
• For four strokes engine read carefully the maintenance
engine manual. Check regularly the oil level and add
some oil or replace it if necessary.
• Frequently check the lawnmower and ensure that all
grass deposits are removed from beneath the deck.
• Lubricate regularly the wheel axle and the bearings
with grease.
• Check often the blade, in order to obtain a clean work
the blade should always be sharp and well balance.
• At regularly intervals check the tightening of all bolts
and screws. Wear off or badly tightening nuts and bolts
can involve some important damages to the engine or
the frame.
• If the blade hits violently an obstacle, stop the lawnmo-
wer and bring it to agreed service station.
THE BLADE: The blade is made of pressed steel, in or-
der to obtain a clean work sharpen the blade frequently,
around every 25 hours of work. Be sure that the blade is
always well balance.
YOU MUST ONLY USE THE MANUFACTURER BALDE
IT SHOULD BE REFERENCED AND WEAR THE MA-
NUFACTURER BRAND "BRM 1446 S"!
To remove the blade, unscrew the screw, check the blade
support and change all spare parts if they are worn out
or damaged.
cutting edges face in the direction of the engine rotation.
The blade screw must be torque to 3.7 Kgm (37Nm) with
a dynamometric tool.
PART OF BAD QUALITY CAN INVOLVE IMPORTANT
DAMAGES TO YOUR LAWNMOWER AND BEPREJU-
DICIAL FOR YOUR SECURITY.

3.1 CLEANING

engine or contaminate the fuel system.
1. Wipe deck with dry cloth.
7
STROAGE
WARNING!
When reassembling the blade, make sure that the
ONLY USE ORIGINAL SPARE PARTS. SPARE
CAUTION: Do not hose engine. Water can damage