Placing And Removing Discs - Panasonic CF-VDRRT2 Bedienungsanleitung

Placing and Removing Discs

This drive's disc cover is designed to be opened electrically. When power is not supplied
to the drive, the disc cover will not open even when the open button is pressed.
Title-side up
CAUTION
Set the disc correctly. (Otherwise, it may spin off and be damaged as a result.)
If power is not supplied to the drive, slide the emergency open lever.
( page 6(F)).
When a program is being used with the drive connected to a computer, exit the
program, and check that the drive's POWER/BUSY indicator lamp is not blink-
ing in orange and that its WRITE indicator lamp has not lighted up in orange.
NOTES
Since the disc cover is locked while a B's CLiP formatted disc is being used,
select [Eject] from the icon displayed on the tasktray to release the lock.
While data is being written, the WRITE indicator lamp lights up and the disc
cover is locked: therefore, the disc cover cannot be opened during data writing.
1
2
3
4
1 Turn on the drive's power.
The drive's ON/OFF power operations
are coupled to the Computer so that
when the PC is turned on or off, the
drive will be automatically turned on or
off.
2 Press the open button.
The disc cover opens slightly.
(The disc cover can also be opened by
selecting [Eject] from the application
software.)
3 Open the disc cover fully.
4 Insert the disc.
Use your fingers to press the part near
the disc center down until the disc is
secured in place.
<Removing the disc>
Check that the disc has stopped turning
completely, and remove it by pressing
down on its center part while clasping
its outer edge and lifting it free.
5 Close the disc cover.
E
13