Technical Data - TorDoc E15 Bedienungsanleitung

7
Fault-finding
Fault
Power LED
fails to come on
Relay not switching
LED on transmitter
and Power LED
still come on
Inadequate range
Replacing the radio modul
If interference occurs in the frequency band being used, the receiver can be converted to
another frequency by replacing the radio module. The transmitter and the radio module
must have the same frequency and the same modulation procedure e.g. AM or FM.
Note the change on the type designation plate.
-Switch off the supply voltage!
-Disconnect the radio module carefully from the connection socket BL1 / Pos. 5.
-Connect a radio module with the required frequency.
-Switch on the supply voltage.
-Delete the radio (see Page 5).
-Teach-in new transmitters.

Technical data

Frequency:
Coding:
Operating voltage:
see type designation plate
Power consumption:
Output:
Operating temperature:
Dimensions:
Weight:
Fault-finding / Technical data
TorDoc Dickert Onlineshop: www.TorDoc.de
Possible cause
- No operating voltage
- Transmitter not taught-in
- Frequency from transmitter and
receiver not identical
- Transmitter switch not actuated
for long enough
- Transmitter defective
- Receiver defective
- Battery in manual transmitter
too weak
- Antenna not connected
or incorrectly laid
- Radio module with 27MHz, 40MH ,
- 12-bit, 18-bit or Keeloq, self-learning, max. 60 codes
(transmitters switch) can be taught-in
- Depending on version:
12 V AC/DC or
- approx. 1.5 VA...3.8 VA (no outputs/all outputs switched on)
- 1- or 4-relay, 1 x UM, potential-free, 250 V AC, 30 V DC,
max. 4 A, 1000 VA, ohmic load per output.
- -20 °C...+50 °C at 30 %...80 % rel. air humidity
- 125 mm x 125 mm x 52 mm Housing plastic, IP54
- approx. 0.6 kg incl. packaging
-
-
- Check transmitter
- Check battery
- Maintain proper distance
z 433MHz
230 V,
± 10 % 50 Hz or
,
24V AC/DC ± 10 % 50 Hz
,
Remedy
- Check connection
Teach-in transmitter
- Use correct transmitter
Actuate switch for at least
1 2 seconds
and replace if necessary
- Check receiver
and replace if necessary
and replace if necessary
from steel equipment
and electrical leads
868
or MHz AM/FM