Safety Instructions - TorDoc E15 Bedienungsanleitung

Safety instructions

Failure to observe these safety instructions can lead to personal injury
and damage to equipment!
Working on the controls
-Switch off the supply voltage!
-Only switch the voltage on again after checking all connections.
Assembly, installation, commissioning and maintenance
-Only by specialist, qualified personnel, e.g. a qualified electrician, who can correctly
assess the safe working condition.
-In accordance with the guidelines and accepted rules of the technology.
Assembly and operation
-The system will only work reliably if carefully assembled in accordance with these instructions.
-This remote control may only be used for devices and systems in which a fault in the
transmitter or receiver does not create any danger to persons or equipment, or in which
such a risk is covered by other safety devices.
- This remote control may not be used for equipment and systems with an increased accident
risk (e.g. crane systems)!
-Remote control of systems involving an accident risk is only recommended, if at all,
with direct line-of-sight contact.
-Observe the applicable local regulations.
-Observe the accident prevention, VDE and EVU regulations.
-Information is available from the VDE and relevant trade associations.
-No technical modifications may be carried out by the user.
Any modifications will invalidate the liability and guarantee conditions.
Assembly instructions
Failure to observe these safety instructions can lead to personal injury
and damage to equipment!
Increased internal temperatures due to direct exposure to sunlight will decrease
the working life.
Water or insects getting into the controls will lead to damage or total failure.
In order to avoid damage to the controls:
-Protect the controls from the effects of weather.
-Install only in the housing.
-Use the attachment holes in the chambers of the cover screws.
-In order to avoid deformation of the housing and leaks, fit only to a smooth undersurface,
and do not over-tighten screws.
-Install vertically, feeding lines in from the bottom.
-Open the twist nipple carefully using a round screwdriver.
Do not cut open with a knife!
Storage and transport conditions
Failure to observe these instructions can lead to failure, even after commissioning!
Store in a dry, dust-free area protected against shocks and impacts.
Storage temperature -20 °C...+80 °C at 30 %...60 % rel. air humidity.
Transport only with adequate and well-padded extra packaging.
-The existing packaging is not intended as transport packaging.
-Damage caused by failure to observe these instructions is not covered by the guarantee!
TorDoc Dickert Onlineshop: www.TorDoc.de
2