Removing; Cleaning; Rectifying Malfunctions - AEG DVB-T 4544 Bedienungsanleitung

Купить в интернет-магазине http://clatronic-shop.com.ua
ENGLISH
42
 Use the "▲ CH+, ▼ CH-" cursor buttons to select the
desired teletext language.
 Press "OK".
 Enter the desired page number using the numeric but-
tons.
 Use the cursor buttons "► V+" and "◄ V-" to scroll
one page forward or backward.
 Press the " INFO" button to enlarge the teletext page.
This function can only be used if the station which
is set offers teletext.
 In order to exit the teletext again, press the "EXIT" but-
ton again.
Selecting an audio setting
This setting can be used to switch between stereo ,V.i (LR),
and mono left (LL) or mono right (RR).
If a programme is broadcasted by using a second
audio programme, you can choose between two
audio channels.
 In order to change audio settings, press the "AUDIO"
button during operation.
 Use the cursor buttons to make your selection or carry
out the adjustments.
 Press the "EXIT" button, in order to return to the nor-
mal screen display.
Programme Swap Button
 To call up the channel which was last selected again,
press the " " button.
Sleep Timer
You can use this function to determine a period after
which the device switches to standby.
 Press the numeric button "0". The screen displays "Sleep
Off".
 Now use the cursor buttons "► V+" and "◄ V-" to
select the period after which the device should be
switched off. You can select among 10, 30, 45, 60, 90
or 120 minutes.
 To disable this function earlier, press the numeric but-
ton "0" until "Sleep Off" appears on the screen.

Removing

 Disconnect the receiver and the connected devices
from the power supply.
 Disconnect the antenna cable from the receiver.
 Remove the batteries from the remote control if you
do not use the receiver for a long period of time.
ТВ-ресивер AEG DVB-T 4544
 Package the receiver, the cables and the remote control
 Store the receiver and all accessories in a dry and dust-
 Protect the receiver from frost.

Cleaning

 Clean the receiver's housing using a dry cloth.

Rectifying malfunctions

in the original packaging.
free location.
Risk of electric shock!
No fluid must enter the receiver. Never clean it with a
wet cloth. Prior to cleaning, remove the mains plug from
the mains socket.
Caution!
Do not use cleaning agents which contain solvents, such
as benzene or thinner. These agents may damage the
surface of the housing.
Symptom Possible cause and remedy
The Power/ The power cable is not connected.
Standby indi-
Connect the power cable to the
cator light is
mains socket.
off.
The mains switch is not switched
on.
Switch the mains switch on.
No sound and The receiver is in standby mode.
no picture,
Press the "STANDBY " button.
control lamp
The receiver switches on and the
on the receiver
channel is shown on the TV screen.
is on.
The receiver is in VCR mode.
Press the DTV/VCR button.
No sound or No signal or a weak signal only.
picture.
Check the cable connection to the
receiver and from the receiver to
the connected devices.
Align the antenna.
The TV set does The system is not connected cor-
not show a rectly.
picture.
Check the SCART or HF cable's
connection.
The TV set is not in AV mode.
Switch the TV set to the relevant
AV input.
Poor picture, The antenna is not aligned cor-
locking error. rectly.
Align the antenna.