Search And Edit Channels; Child Protection/Password (Pin Code); Factory Defaults - AEG DVB-T 4544 Bedienungsanleitung

Купить в интернет-магазине http://clatronic-shop.com.ua

Search and edit channels

In order to quickly search a channel or to change the
features of saved channels, select the "SETUP/Installation"
submenu.
Automatic channel search (Auto/Scan):
 Start the automatic channel search with the "red" but-
ton.
 Press the "OK" button.
All available channels will be searched and stored in a
programme slot.
Manual search (Manual Scan):
The individual settings for a channel can be adjusted in
this menu.
For this purpose it is necessary that you know the channel
number of the station concerned.
 Press the "green" button to call up the "Manual Scan"
menu.
 For changing the settings, use the"◄ V-" and "► V+"
cursor buttons.
 After having carried out all settings, the search run is
activated by pressing the "OK" button.
All channels found in the area will be stored in a pro-
gramme slot.

Child Protection/Password (PIN code)

In the "Password", you can carry out the following set-
tings:
• the "Menu Lock" (Setting Menu Lock),
• set the "channel lock" (child lock),
• set the "censorship lock",
• changing the password.
Menu Lock
In this menu you can set whether the password has to be
entered in order to call up the SETUP menu.
Child Lock
In the "TV/TV List" menu (see page 37) you can block
individual channels. With the "channel lock" function you
can switch this lock on and off.
 If you would like to switch on the child lock, select the
"on" option.
 If you would like to switch off the child lock, select the
"off' option.
ТВ-ресивер AEG DVB-T 4544
Censorship Lock
In this menu you can choose between:
• "No block"
• "Total block" = all channels and some menu options
• "2" to "18" = Here you can determine the desired age
Changing the password
You may change the password (PIN code) set in the
factory and enter any other four-digit number as your
personal PIN code. The password "0000" has been pre-
programmed in the factory.
 Enter the old password (PIN) using the numeric
 Enter the new password using the numeric buttons.
 Enter the new password again.
The information window "PIN code changed" appears.
 Press the "OK" button to confirm.
The new password is integrated.

Factory defaults

 Select the "Set Default" submenu in the "SETUP" menu
 Press the "OK" button to confirm.
You will be prompted to confirm your selection.
 Press the "red" button if you would like to return the
 Press the "EXIT" button if you would like to exit the
 Wait until the receiver re-starts.
This process may take a few minutes. The installation
menu then appears.
 Press the "EXIT" button to return to the TV channel.
can only be released after the password has been
entered.
rating. This function must be supported by the chan-
nel, which must transmit appropriate data.
Note your new password; once changed, only the
new code is valid for all password queries.
If you've forgotten your personal password, you
can assign a new password by means of the mas-
ter password "8888".
buttons.
The receiver is reset to its condition on delivery. All
of your settings and stored data are deleted.
by using the "▼ CH-" and "▲ CH+" cursor buttons.
receiver back to the factory settings.
menu.
ENGLISH
35