12 9. Additional Information; Upgrading The Receiver Software; 13 9.2 Software Transfer (Receiver To Receiver); 13 9.3 Master Password - Radix DTR 9000PVR Bedienungsanleitung

DIGITAL TERRESTRIAL RECEIVER DIGITAL TERRESTRIAL RECEIVER
Additional Information
9. Additional Information

9.1 Upgrading the Receiver Software

You can upgrade the software on the Receiver. To upgrade the software on the Receiver, contact the
store where you purchased the set. To check the software version, select "System Information" from
the Main Menu and then press the OK button. After the software upgrade, you may need to perform
Reinstallation on the Receiver. Refer to Section 8.7 on information on Reinstallation.
Caution
When you perform Reinstallation, all existing data will be lost.
Connect the cable.
Run the programme from your PC.
Turn off the Receiver and then turn it back on.
Please visit our website
[http://www.radixworld.com/korea/product/download.asp and click Download Guide]
[http://www.radix-sat.de]
GB GB
9.2 Software Transfer(Receiver to Receiver)
The S/W transfer function from receiver to another receiver.
1. Plug the power cable in the forwarding Receiver in order to transmit S/W and take out the power plug
from receiving receiver.
2. Connect forwarding receiver with receiving receiver by the RS232 cable.
3. Set the forwarding receiver on the system information screen.
4. Press [TIMER]key of forwarding receiver.(Find "Progress bar" on the screen)
5. Plug the power cable in the receiving receiver.
6. After "progress bar" is full, wait until the "complete" message shown.
After complete transmission, you need to reboot the receiving receiver in order to apply received
software.
Attention: It will be possible to lose transmission by electricity effect.
And then, you may be able to install several times.
If possible, please avoid to use the RCU while the software is downloading.
9.3 Master Passwor d
The Master Password is the general password you will need to use to access the Receiver if you have
forgotten your User Password. The following 4-digit number is the Master Password. It is
recommended that you record your User Password in the space provided below. The User Password is
set to "0000" by default.
• Master Password
9 8 1 5
• User Password
22

10. Trouble Shooting

Note:
Digital communications involve the simultaneous transfer and processing of large amounts of data.
Changing channels may take longer in comparison to analogue devices.
Problem
- Channel Data changed. - Execute Re-Installation or Manual/Auto Channel
1) No Video
Search (Please refer to the Manual for details).
- Check the audio mute controls- Check Audio Language; Press Audio Key and
2) No Audio try to change the language or change Main Audio language on general
settings menu.
3) Fail to boot receiver. - Reapply AC power- Contact A/S Center if this problem occurs continuously.
4) Fail to search channel - signal Line connection
5) Screen shows No Signal
- signal Line connection
continuously
- Bad Signal stream or bad channel; move to another channel - Reapply AC
6) Video Freeze
power
- Receiver could be interfered with Noise from other electric home appliances.
7) Remote control
Put the receiver in some other place. - Check if the battery of Remote Control
does not respond
is empty.
8) Fail to catch Preprogram - Execute the Re-Installation process or Manual/Auto Search.
channel
9) No OSD MENU - Check SCART, ensure it is connected to your receiver and TV correctly
10) Fail to Download
- PC232 Port problem
through Serial

11. Recycling and Disposal

Please dispose of the device, packaging such as polystyrene and all batteries in accordance with your local
regulations and recycle wherever possible, Follow all relevant regulations and dispose of the materials at
the correct locations. Consult the relevant regulations available from your local environmental protection
agency or similar.
DTR 9000PVR DTR 9000PVR
Trouble Shooting
Solution
GB GB
23