Hdd Standby Timer Setting; Reinstallation; 8.8 Recording And Playback 7 8.8.1 Recording; Instant Recording - Radix DTR 9000PVR Bedienungsanleitung

DIGITAL TERRESTRIAL RECEIVER DIGITAL TERRESTRIAL RECEIVER

HDD Standby Timer setting

8.6.3 HDD Standby Timer setting
This menu is used to save power consumed by the
HDD. If this is set to 10 minutes, the HDD goes into
Standby mode after 10 minutes of non-use.
• Toggle with Left / Right buttons to adjust this parameter.
8.7

Reinstallation

If you have changed or deleted preset data and wish
to reset the receiver to the factory presets:
• Choose this option with OK and enter the password :
( 0 0 0 0)
GB GB
By performing a Reinstallation you will loose all
favorite list settings and all other setting performed
since the first start-up.
8.8 Recording and Playback
This receiver can record programmes digitally and
play them back
8.8.1 Recording

8.8.1.1 Instant Recording

• To make an instant recording, press REC button on
the RCU and recording will begin.
A recording icon will appear in the top right hand corner
of the screen when a recording is in progress.
• To stop recording, press Stop button on the RCU.
When the information menu is displayed in the lower
half of the screen press OK button to stop recording
or Exit button to continue recording.
8.8.1.2 Recording with Timer (Timer Function)
You can use the timer function so that your receiver
automatically switch on / off or changes the channel at
a preset time so that you can record a programme
using a connected video recorder. You can also use
this function to automatically change channels if
you don't want to miss the start of a programme but
want to watch to another channel until then.
The timer function allows you to set a list with all the
required timer settings in which you can set the date
and time for the receiver to be switched on and off the
channel and if necessary the daily or weekly repeat of
each switching operation.
18
If you are currently watching a channel and
timer switching operation is pending, the
receiver reminds you by overlaying a massage
that the timer switching operation will take
place in one minute. When this time is
reached, the receiver switches over to the
required channel and "Rec" is displayed on
the front display. After the preset time has
expired, the receiver switches back to the
original channel.
How to programme the timer:
• Press TIMER button on the RCU.
If you have not yet specified the actual date or time you will now be asked to. Use the numeric
button. As soon as you have done this the following screen will be displayed:
This list shows all of the programmed recordings. All settings can be changed or deleted. In the
column "Modus" you can see if the timer function is set for once only, daily or weekly.
• Press "OK" button, you can enter a new timer setting.
You will then see the following display:
In this menu you can enter all the settings for the timed switching operation. Then, select menu
item 8 and confirm with "OK" to return to the list
• To delete an entry from the list, select it using the UP/DN buttons and then press L/R. Confirm your
selection with "OK"
• Press "Exit" to return to TV mode.

8.8.1.3 EPG Recording

Press EPG button on the RCU to display the
Electroic Programme Guide.
Select a programme you would like to record
by using UP/Down buttons and press the
"Timer" button. When EPG record information
is displayed, press "OK" to reserve the
recording. The selected programme will now
appear in the Recording list.
• Press the Info(i) button on the RCU to either
show or hide the progress bar

8.8.2 HDD Recorded List

Press the LIST button on the RCU to display
the recorded list.
DTR 9000PVR DTR 9000PVR
EPG Recording
GB GB
19