Troubleshooting; Safety Regulations - Gastros InductWarm 130 Betriebs- Und Montageanleitung

Operation
The four power levels of the InductWarm 130 cover different warming levels. The temperature levels are indications
®
only. The actual temperature depends on: material of the dish, surrounding temperature, size of the dish and the
positioning above the coil.
The InductWarm 130 has a dish detection. This ensures that the induction field is only active when placing an
®
inductive dish on top. When the InductWarm 130 is operating with a dish, the small LEDs are shining. If the dish
®
will be removed, the InductWarm 130 system recognizes the situation and turns off automatically. This is being
®
indicated by four blinking LEDs. If the dish will be replaced within five minutes the system starts warming on the
same level as before, after that the systems will switch to standby mode. The InductWarm
induction capable dishes.
Connecting cable
Only connect three InductWarm 130 device with one 48 cm connecting cable. Then it is possible to supply this three devices
®
with one 230V power outlet.
1
8
Technical Information of the InductWarm
Voltage range
Maximum input power
Electrical fuse protection
Frequency
Dimensions
Connection
Infra Red Receiver
LED 1-4
Power Button
130 can be used wih any
®
® 130 Built-in Element
220 – 240 V AC
750 W
10 A
50 Hz
350 x 350 x 110 mm
C13

Troubleshooting

Possible Problems
Fault
LED is not flashing
LED flashing
Infra red remote control is not
working
Dish is not warm enough

Safety Regulations

Responsibility
The InductWarm 130 reflects the state of the art and has been built in accordance with the valid CE guidelines. Safe
®
operation is assured. The InductWarm
sical or mental limitations, unless they are instructed and monitored while using the appliance by a person respon-
sible for their safety.
19 20
Cause Remedy
Plug the appliance in,
No power supply
check the plug connection
Power line fuse tripped Check and reset the fuse
Check the plug connection, turn on
Appliance not switched on the power switch on the bottom of
the device
Appliance defect Contact customer service
Pan too small or not
Pan is not detected
induction compatible
Battery is empty Replace the battery
Sender or receiver are solid Clean sender or receiver
No elecrticity between battery and Ensure contact between battery and
remote control remote control
Ensure right position above the
Incorrect placement of dish
induction coil
Too little energy input Increase power level
Check induction compatibility of
Dish is not induction compatible
dish
130 appliance is not intended to be operated by children or persons with phy-
®