Before Use - ROWENTA DW9210 ECO INTELLIGENCE Gebrauchsanweisung

IMPORTANT RECOMMANDATIONS
• The voltage of your electrical installation must correspond to that of the iron (220-
240V). Always plug your iron into an earth socket. Connecting to the wrong voltage
may cause irreversible damage to the iron and will invalidate the guarantee.
• If you are using a mains extension lead, ensure that it is corrected rated (16A) with
an earth, and is fully extended.
• If the electric power cord is damaged, it must be replaced by an Approved Service
Centre in order to prevent any danger.
• Do not unplug your appliance by pulling on the cord.
• Never immerse your steam iron in water or any other liquid. Never hold it under the
water tap.
• Never touch the electric cord with the soleplate of the iron.
• Your appliance gives off steam, which may cause burns, especially when you are
ironing close to the edge of your ironing board.
• Never direct the steam towards people or animals.
• For your saftey, this appliance conforms to the applicable standards and regulations
(Low Voltage, Electromagnetic Compatibility, Environmental Directives).
• This product has been designed for domestic use only. Any commercial use,
inappropriate use or failure to comply with the instructions, the manufacturer accepts
no responsibility and the guarantee will not apply.
ENVIRONMENT PROTECTION FIRST !
Your appliance contains valuable materials which can be recovered or
recycled.
Leave it at a local civic waste collection point.
DESCRIPTION
Spray nozzle
1
Filling inlet
2
(with slide-button opening)
Eco steam system
3
Dry ironing
a
ECO position
b
BOOST position
C
Shot of steam button
4
Cord
5

BEFORE USE

WARNING ! Remove any labels from the soleplate before heating up the iron.
WARNING ! Before using your iron with the steam function for the first time, we recommend
that you operate it in a horizontal position for a few moments, away from your linen, i.e. press
the Shot of Steam button a few times.
Upon the first use, you may notice small particles coming out of the soleplate. This is parf of
manufacturing process and is not harmful to you or your garments. It will disappear after
several uses. You may accelerate this by using the self cleaning function (fig 5a – 5b) and
shaking the iron gently.
1 • What water may be used ?
Your iron has been designed to operate using untreated tap water. If in doubt, check
with your local water authority. However, if your water is very hard, you can mix
50% untreated tap water with 50% distilled or demineralised water.
IMPORTANT Heat concentrates the elements contained in water during evaporation. The
types of water listed below contain organic waste or mineral elements that can cause
spitting, brown staining or premature wear of the appliance : water from clothes dryers,
scented or softened water, water from refrigerators, batteries or air conditioners, pure
distilled or demineralised water or rain water should not be used in your iron. Also do not use
boiled, filtered or bottled water.
IRONING BOARD: Due to the powerful steam output, a mesh type ironing board must be used
to allow any excess steam to escape and to avoid steam venting sideways.
Keep these instructions
Handle
6
Thermostat control light
7
Spray trigger
8
Temperature control dial
9
Water tank
10
Self clean button
11
Maximum water level indicator
12
Soleplate
13
High Precision TIP
14
3