Thermor Pass Program Kit Fil Pilote Bedienungsanleitung Seite 16

c- How to install the interface on your appliance?
1) Remove the appliance from the wall (after switching off the
power supply).
2) Remove the transparent protective cover with a screwdriver.
3) Place the interface in the housing for it in the appliance's casing.
4) Fasten the interface in place using the 2 screws provided (do
not use any other type of screw). Screw it in tightly.
5) Refit the appliance on its brackets and switch it ON.
6) Insert the programmer in the interface.
Connector facing downwards
Press it in fully
Do not bend the contact lugs.
Rear side facing the wall
programmer is correctly connected).
SCREW
The indicator
light should flash
five times in suc-
cession (to con-
firm that the