Sleep Mode; Child Safety - Thermor Pass Program Kit Fil Pilote Bedienungsanleitung

Sleep mode

The programmer's display automatically goes into Sleep mode if
the buttons are not used for 4 minutes.

Child safety

Hold down button
grammer to Child Safety mode (the buttons are then disabled).
Repeat the procedure to reactivate the programmer.
Configuring the display
Hold down buttons
ton on the back of the programmer using a pointed object (a
pen).The day flashes.You can then change the display by press-
ing button
Confirm by pressing button
I
NSTALLATION USING A PILOT WIRE
Some precautions and advice on use.
Before installing the interface, check that the programmer's pilot
wire (black conductor) is connected to a spare connection block
or to a pilot circuit only containing electronic control units
(Drawings 1 & 2).
Under no circumstances may the pilot wire for a unit fitted with
an interface be:
Connected to a Live conductor (Drawing 3).
Connected to another timer (Drawing 3).
Connected to a Neutral conductor (Drawing 4).
An appliance fitted with a programmer can handle a maximum of
15 electronic control units.
and then press button
and
.
and briefly press the RESET but-
.
FIG. 1
Locking pin
Fuse
Screw
to set the pro-
I
NTERFACE