Troubleshooting; Technical Data - Glomar EKS-2-ULTRA Bedienungsanleitung

Bedienungsanleitung / Instruction Manual EKS-2-ULTRA
4.3 Service and maintenance instruction
The electric-hydraulic cutting unit is equipped with a so-
phisticated controller enabling the user to see when the
next service is due. When the next service is due the unit
must to be returned to an authorised service centre.
Attention
Keep the blades clean and grease the guidance
regularly.
Within the determined use of the tool only the blades are
permitted to be changed by the customers. If the seals
are damaged the warranty is invalidated.
Attention
Do not damage the seals of the tool. If the seals
are damaged the warranty is invalidated.
Have your tool serviced only by quali ed service person-
nel and replace parts only with genuine spare parts. This
will make sure that the safety standard of the tool will be
preserved.
5.

Troubleshooting

a.) Constant  ashing/indicating of the light diode display
(page I, pic 1, 1) .
see table 1. If the failure can not be solved through
the action recommended in table 1 return the tool to
the nearest service center (ASC).
b.) The tool loses oil.
Return the unit to the manufacturer. Do not open it
and damage the seal of the tool.
6.

Technical Data

Weight approx. 4,7 kg
(incl. battery):
Cutting force: approx. 60 kN
Maximum Ø 50 mm
cutting diameter:
Driving motor: direct-current permanent  eld
Battery voltage: 18 V DC
Battery capacity: 3 Ah (RAL2/BL1830)
Charging time: 22 min. (RAL2/BL1830)
Cutting time: approx. 8 s to 18 s
(depending on the connector size)
Cuts per battery approx. 140 cuts
charge: (4x120 mm² NYY)
Hydraulic oil: Rivolta S.B.H. 11
Environmental -20°C bis +40°C
temperature:
Sound level: 70 dB (A) in 1m distance
Vibrations: < 2,5 m/s²
Dimensions: See pic. 2
7. Putting out of operation/waste dis-
posal
This unit is subjected to the scope of the European WEEE
(2002/96/EG) and RoHS (2002/95/EEC) directives.
11